Abstract The high inertia, i.e. high mass and low speed, of a landing spacecraft has the potential to drive a penetrometer into the subsurface without the need for a dedicated deployment mechanism, e.g., during Huygens landing on Titan. Such a method could complement focused subsurface exploration missions, particularly in the low gravity environments of comets and asteroids, as it is conducive to conducting surveys and to the deployment of sensor networks. We make full-scale laboratory simulations of a landing spacecraft with a penetrometer attached to its base plate. The tip design is based on that used in terrestrial Cone Penetration Testing (CPT) with a large enough shaft diameter to house instruments for analysing pristine subsurface material. Penetrometer measurements are made in a variety of regolith analogue materials and target compaction states. For comparison a copy of the ACC-E penetrometer from the Huygens mission to Titan is used. A test rig at the Open University is used and is operated over a range of speeds from 0.9 to 3ms−1 and under two gravitational accelerations. The penetrometer was found to be sensitive to the target’s compaction state with a high degree of repeatability. The penetrometer measurements also produced unique pressure profile shapes for each material. Measurements in limestone powder produced an exponential increase in pressure with depth possibly due to increasing compaction with depth. Measurements in sand produced an almost linear increase in pressure with depth. Iron powder produced significantly higher pressures than sand presumably due to the rough surface of the grains increasing the grain-grain friction. Impacts into foamglas produced with both ACC-E and the large penetrometer produced an initial increase in pressure followed by a leveling off as expected in a consolidated material. Measurements in sand suggest that the pressure on the tip is not significantly dependent on speed over the range tested, which suggests bearing strength equations could be applied to impact penetrometry in sand-like regoliths. In terms of performance we find the inertia of a landing spacecraft, with a mass of 100kg, is adequate to penetrate regoliths expected on the surface of Solar System bodies. Limestone powder, an analogue for a dusty surface, offered very little resistance allowing full penetration of the target container. Both iron powder, representing a stronger coarse grained regolith, and foamglas, representing a consolidated comet crust, could be penetrated to similar depths of around two to three tip diameters. Speed tests suggest a linear dependence of penetration depth on impact speed.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Using the inertia of spacecraft during landing to penetrate regoliths of the Solar System


    Beteiligte:
    Paton, M.D. (Autor:in) / Green, S.F. (Autor:in) / Ball, A.J. (Autor:in) / Zarnecki, J.C. (Autor:in) / Harri, A.-M. (Autor:in)

    Erschienen in:

    Advances in Space Research ; 56 , 6 ; 1242-1263


    Erscheinungsdatum :

    2015-06-20


    Format / Umfang :

    22 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch






    Functional Comparison of Lunar Regoliths and Their Simulants

    Rickman, Doug / Edmunson, Jennifer / McLemore, Carole | ASCE | 2012


    SPACECRAFT LANDING DEVICE

    AKULOV JURIJ PETROVICH / LOMAKIN ILJA VLADIMIROVICH / MARTYNOV MAKSIM BORISOVICH et al. | Europäisches Patentamt | 2016

    Freier Zugriff

    Spacecraft Landing Systems

    Kiker, John W. / Norman, Leland C. | SAE Technical Papers | 1967