Abstract The established state-of-the-art for composite solid propellant grain manufacture consists in mix-cast-cure process using hazardous chemicals and specific molds for propellant forming. In most of the cases, polyaddition of oligomers involves isocyanate functional groups. Construction constraints limit the feasibility of propellant geometries, confining the pressure-time history of rocket motors to some established configurations. Composition pot-life becomes one of the most important parameters in the definition of correlated industrial processes. An additive manufacturing process for propellant grain production based on UV curing has been recently proposed for patenting. This technique enables more complex grain geometries, paving the way for new propulsive missions, thanks to customized thrust-time profiles or local composition fine tuning. The new curative method makes innovative use of pre-polymers, replacing isocyanates with UV-sensitive components characterized by lower chemical hazard for operators. The paper illustrates the experimental results obtained during the preliminary test campaign on propellant inert simulators, produced as lab-scale proof of concept. The activity targeted mono-layer samples, focusing on binder properties. Dynamic-mechanical thermal analysis, thermal-gravimetric analysis, and stress–strain tests have been carried out to measure mechanical and physical characteristics of different formulations. Both hydroxyl-terminated polybutadiene (HTPB) and polybutadiene diacrylate (PBDDA) binders have been considered, using ammonium sulfate as substitute of ammonium perchlorate. Aluminized and non-aluminized samples have been manufactured to evaluate the impact of opaque-reflective materials during the UV curing process. The reported analyses show comparable results for both the new UV-cured materials and demonstrate the feasibility of propellants based on isocyanate-free process.

    Highlights Solid propellants are produced without isocyanates using photo-polymerization. Photo-polymerization can work with HTPB, PBDDA, and some nonfunctional polymers. Removal of isocyanates can reduce operator risks and environmental issues. Photo-polymerization enables additive manufacturing of solid propellant grains.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Photo-polymerization for additive manufacturing of composite solid propellants


    Beteiligte:
    Garino, Simone (Autor:in) / Antonaci, Paola (Autor:in) / Pastrone, Dario (Autor:in) / Sangermano, Marco (Autor:in) / Maggi, Filippo (Autor:in)

    Erschienen in:

    Acta Astronautica ; 182 ; 58-65


    Erscheinungsdatum :

    2021-01-30


    Format / Umfang :

    8 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Ignition Delay Times of Composite Solid Propellants Using Novel Nano-Additive Catalysts

    Demko, Andrew R. / Dillier, Catherine / Petersen, Eric L. et al. | AIAA | 2015


    Ignition Delay Times of Composite Solid Propellants Using Novel Nano-Additive Catalysts

    Demko, Andrew R. / Dillier, Catherine / Sammet, Thomas et al. | AIAA | 2018


    Modeling of Aluminized Composite Solid Propellants

    Wang, Xiaojian / Jackson, Thomas | AIAA | 2004


    Mechanistic studies on composite-solid propellants

    KISHORE, K. / PAI VERNEKER / V. R. et al. | AIAA | 1977