This article dealt with the comparison of results obtained from an experiment and from the numerical thermal FEM analysis. Sample with defects were printed on a 3D printer. A thermal wave from the halogen lamp to excite the front surface of the sample was used in the next step and the response was measured by a thermal camera. After processing the data in the software DisplayIMG, a phase image was created representing the 2D image of the material at a certain depth under the surface of the model. Lock-in method was applied to the results from the numerical thermal FEM analysis and the phase image was created. The programs code were created in MATLAB for a 4 points, multiple points and differential lockin method which were compared with the results from the experiment.


    Zugriff

    Download


    Exportieren, teilen und zitieren



    Titel :

    PROCESSING OF RESULTS FROM A THERMAL FEM ANALYSIS USING THE LOCK-IN METHOD AND COMPARISON WITH EXPERIMENT


    Beteiligte:
    Ondrej ŠTALMACH (Autor:in) / Vladimír DEKÝŠ (Autor:in) / Pavol NOVÁK (Autor:in) / Milan SAPIETA (Autor:in)


    Erscheinungsdatum :

    2019




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Unbekannt




    SMOKE AEROSOL MEASUREMENT EXPERIMENT-2: COMPARISON OF FLIGHT EXPERIMENT RESULTS WITH GROUND TEST RESULTS

    Meyer, M.E. / Urban, D.L. / Ruff, G.A. et al. | British Library Conference Proceedings | 2013


    Smoke Aerosol Measurement Experiment-2: Comparison of Flight Experiment Results with Ground Test Results

    Meyer, Marit E. / Urban, David L. / Ruff, Gary A. et al. | AIAA | 2013