The phenomenon of fatigue crack arrest in surface-hardened cylindrical specimens with stress concentrators is examined from the perspective of linear fracture mechanics. The stress intensity coefficient (SIC) is considered as the criterion, its scope determines the speed of fatigue crack growth in the case of cyclic loading. The calculations of the study were carried out by the Finite Elements Modeling method using the calculation complex ANSYS. The calculation complex ANSYS that uses the Finite Elements Modeling method in the form of displacements was applied to determine the stress intensity coefficient under bending of cylindrical surface-hardened and non- hardened specimens with the diameter of 10 mm with a semicircular notch with the radius of 0,5 mm. It is established that the stress intensity coefficient has two extremes in the initial area of the fatigue crack development: the minimum and maximum values. The results of the calculation indicate that the minimum value of SIC is lower than its threshold value below which the crack does not develop in the case of a cylindrical surface-hardened notched specimen. This fact is in good agreement with the results of tests of these specimens as non-propagating fatigue cracks were revealed in these specimens only. It is also established that the depth of a crack is approximately 0,02 of the minimum size of the section of a cylindrical specimen for the maximum value of the stress intensity coefficient. The study carried out validates the use of the criterion of average integral residual stresses to calculate the increase of the endurance limit of surface-hardened specimens and parts with stress concentrators due to compressive residual stresses.


    Zugriff

    Download


    Exportieren, teilen und zitieren



    A New Method of Fatigue Life Prediction for Notched Specimen

    JIN Dan / GOU Zhifei | DOAJ | 2017

    Freier Zugriff

    Fatigue Crack Propagation in Severely Notched Bars

    Hyler, W S / Abraham, E D / Grover, H J | NTRS | 1956



    Design and Optimization of an Axial Mode II Crack Arrest Specimen

    Cheung, C.H.E. / Lin, K.Y. / Gray, P. et al. | British Library Conference Proceedings | 2012


    Design and Experimental Validation of a Mixed-Mode Crack Arrest Specimen

    Bruun, E. / Lin, K.Y. / Cheung, C. et al. | British Library Conference Proceedings | 2012