In this study, the hysteresis based direct torque control (DTC) of a three-phase induction motor was carried out experimentally. The DTC algorithm was also modelled in the hardware environment by using FPGA’s in-the-loop feature. The dSPACE DS1103 controller board was used in the experimental study and Altera DE2-115 model development board was used in the hardware modelling. Both applications had the same sample time and all of the DTC algorithm was tested within the FPGA. The hardware simulation study conducted in FPGA environment was carried out in MATLAB/Simulink environment. The experimental results were compared with the hardware simulation results obtained from FPGA. As a result of the comparison, it was shown that DTC algorithm could be realized easily in FPGA environment without experimental installation, and the obtained current, voltage and velocity graphs were similar.


    Zugriff

    Download


    Exportieren, teilen und zitieren



    Titel :

    FPGA in-the-loop implementation of direct torque control for induction motor


    Beteiligte:
    Gundogdu, Ahmet (Autor:in) / Celikel, Resat (Autor:in) / Dandil, Besir (Autor:in) / Ata, Fikret (Autor:in)

    Erscheinungsdatum :

    2021-01-01


    Anmerkungen:

    Automatika : časopis za automatiku, mjerenje, elektroniku, računarstvo i komunikacije ; ISSN 0005-1144 (Print) ; ISSN 1848-3380 (Online) ; Volume 62 ; Issue 2


    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Klassifikation :

    DDC:    629