In robotic operations where a manipulator is involved, it is well-known that the quantities measured by a wrist force/torque sensor are corrupted by the dynamicsof the end effector and manipulator. To solve this problem,an observer, which fuses information from force sensors andaccelerometers, was designed recently in order to estimate the contact force exerted by a manipulator to its environment [1]. This paper introduced a high-speed, high-accuracy, versatile, simple, and fully autonomous technique for the calibration of this robotic manipulator 3D force observer by means of active motion. To verify the improvement, an impedance control scheme was used. A dynamic model of the robot-grinding tool using the new sensors was obtained by system identification. The experiments were carried out on an ABB industrial robot with open control system architecture.


    Zugriff

    Download


    Exportieren, teilen und zitieren



    Titel :

    Self Calibrating Procedure for a 3D Force Observer


    Beteiligte:

    Erscheinungsdatum :

    2005-01-01


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Klassifikation :

    DDC:    629



    Automatic Calibration Procedure for a Robotic Manipulator Force Observer

    Gámez García, Javier / Robertsson, Anders / Gómez Ortega, Juan et al. | BASE | 2005

    Freier Zugriff

    Self-calibrating radiometer

    Dimeff, J. | NTRS | 1977


    Procedure for Calibrating Gipps Car-Following Model

    Mehran, Babak | Online Contents | 2009


    Procedure for Calibrating Gipps Car-Following Model

    Rakha, Hesham / Wang, Weidong | Transportation Research Record | 2009


    Practical Procedure for Calibrating Microscopic Traffic Simulation Models

    Hourdakis, John / Michalopoulos, Panos G. / Kottommannil, Jiji | Transportation Research Record | 2003