This paper presents a novel procedure for robotic scanning of weld grooves in large tubular T-joints. The procedure is designed to record the discrete weld groove scans using a commercially available line laser scanner which is attached to the robot end-effector. The advantage of the proposed algorithm is that it does not require any prior knowledge of the joint interface geometry, while only two initial scanning positions have to be specified. The position and orientation of the following scan are calculated using the data from two previous weld groove scans, so once initiated, the scanning process is fully autonomous. The procedure is a two-step algorithm consisting of the prediction and correction substeps, where the position and orientation of the sensor for the following scan are predicted and corrected. Such a procedure does not require frequent weld groove scanning for navigation along the groove. The performance of the proposed procedure is studied experimentally using an industrial-size T-joint specimen. Several cases of scanning motion parameters have been tested, and a discussion on the results is given. ; publishedVersion
Robotic weld groove scanning for large tubular T-joints using a line laser sensor
2022-01-01
cristin:2010691
4525-4538 ; 120 ; The International Journal of Advanced Manufacturing Technology
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
DDC: | 629 |
Robotic weld groove scanning for large tubular T-joints using a line laser sensor
BASE | 2022
|Robotic weld groove scanning for large tubular T-joints using a line laser sensor
BASE | 2022
|Coatings for pipe line weld field joints
Tema Archiv | 1990
|U-groove aluminum weld strength improvement
Tema Archiv | 1996
|U-Groove Aluminum Weld Strength Improvement
British Library Conference Proceedings | 1996
|