1. Introduction -- 1.1. What is vehicle rollover? -- 1.2. Risk of vehicle rollover accidents -- 1.3. Factors affecting vehicle rollover -- 1.4. Summary

    2. Dynamic model of vehicle rollover -- 2.1. Roll plane model -- 2.2. Yaw-roll model -- 2.3. Lateral-yaw-roll model -- 2.4. Yaw-roll-vertical model -- 2.5. Multi-freedom model -- 2.6. Multi-body dynamic model -- 2.7. Summary

    3. Stability of untripped vehicle rollover -- 3.1. Roll index of untripped vehicle rollover -- 3.2. Rollover warning -- 3.3. Summary

    4. Stability of tripped vehicle rollover -- 4.1. Roll index of tripped vehicle rollover -- 4.2. Energy methods -- 4.3. Summary

    5. Active control for vehicle rollover avoidance -- 5.1. Anti-roll bar system -- 5.2. Active suspension system -- 5.3. Active steering system -- 5.4. Active braking system -- 5.5. Integrated chassis system -- 5.6. Summary

    6. Rollover control strategies and algorithms -- 6.1. Proportional-integral-derivative control method -- 6.2. H-infinity control method -- 6.3. Model prediction control method -- 6.4. Linear quadratic regulator control method -- 6.5. Sliding mode control method -- 6.6. Summary -- 7. Conclusions

    Vehicle rollover accidents have been a serious safety problem for the last three decades. Although rollovers are a small percentage of all traffic accidents, they do account for a large proportion of severe and fatal injuries. Specifically, some large passenger vehicles, such as large vans, pickup trucks, and sport utility vehicles, are more prone to rollover accidents with a high center of gravity (CG) and narrow track width. Vehicle rollover accidents may be grouped into two categories: tripped and untripped rollovers. A tripped rollover commonly occurs when a vehicle skids and digs its tires into soft soil or hits a tripping mechanism such as a curb with a sufficiently large lateral velocity. On the other hand, the untripped rollover is induced by extreme maneuvers during critical driving situations, such as excessive speed during cornering, obstacle avoidance, and severe lane change maneuver. In these situations, the forces at the tire-road contact point are large enough to cause the vehicle to roll over. Furthermore, vehicle rollover may occur due to external disturbances such as side-wind and steering excitation. Therefore, it is necessary to investigate the dynamic stability and control of tripped and untripped vehicle rollover so as to avoid vehicle rollover accidents. In this book, different dynamic models are used to describe the vehicle rollover under both untripped and special tripped situations. From the vehicle dynamics theory, rollover indices are deduced, and the dynamic stabilities of vehicle rollover are analyzed. In addition, some active control strategies are discussed to improve the anti-rollover performance of the vehicle


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Dynamic stability and control of tripped and untripped vehicle rollover


    Beteiligte:
    Jin, Zhilin (Autor:in) / Li, Bin (Autor:in) / Li, Jingxuan (Autor:in)


    Erscheinungsdatum :

    2019


    Format / Umfang :

    viii, 112 Seiten


    Anmerkungen:

    Illustrationen, Diagramme
    Literaturangaben: Seite 103-109



    Medientyp :

    Buch


    Format :

    Print


    Sprache :

    Englisch



    Klassifikation :

    BKL:    55.84 Straßenverkehr / 55.20 Straßenfahrzeugtechnik
    DDC:    629.2/31



    Dynamic stability and control of tripped and untripped vehicle rollover

    Jin, Zhilin / Li, Bin / Li, Jingxuan | TIBKAT | 2019


    Stability and optimised h-infinity control of tripped and untripped vehicle rollover

    Jin,Z. / Zhang,L. / Zhang,J. et al. | Kraftfahrwesen | 2016



    Sensitivity Analysis of Vehicle Tripped Rollover Model

    A. G. Nalecz / A. C. Bindemann / C. Bare | NTIS | 1988


    U15: Tripped Rollover (Phase A)

    D. B. Pape / J. T. Holdridge / J. C. Chitwood et al. | NTIS | 2009